Digimore Electronics Co., Ltd

BT10-1

Bluetooth 4.2 and Proprietary 2.4Ghz Module

Digimore's Bluetooth low energy 4.2 and Proprietary 2.4Ghz Module is a multi-protocol RF module using NORDIC SoC nRF51802. The module has been designed to provide ultra-low power, low cost and robust 2.4 GHz communications and compliant with Bluetooth Version 4.2 low energy (BLE, Single Mode) solution. This module is ideal for low power wireless sensing device applications such as mobile phone accessories, sports, consumer electronics, HID and etc.

FEATURE

Bluetooth version 4.2 low energy (LE, single mode) compliant
Range of proprietary 2.4Ghz protocols
On-air compatibility with nRF24L series
Powerful ARM® Cortex® -M0 micro-controller
256 KB in-system-programmable flash + up to 16KB of system SRAM
Wide supply voltage range (1.8 to 3.6V) and with lowest power
Powerful peripherals
Excellent receiver sensitivity
Programmable output power
On board PCB antenna and crystal
Module Dimension: 14.3mm x 14.3mm FR4 PCB
Module Thickness: 2.0mm

SPECIFICATION

Absolute Maximum Ratings
Supply Voltage	- 0.3 ~ 3.9 V
Voltage on any digital/ analog IO	- 0.3 ~ VCC_nRF +0.3V
Input amplitude driven by external clock on XL1	200 ~ 600 mV pp
Input RF level	5dBm
Storage temperature range	-40 ~ 125 oC
Recommended Operating Conditions
Operating supply voltage	1.8 ~ 3.6 V
Operating ambient temperature range, TA	-25 ~ 75 oC
DC Characteristics TA=25oC, VCC_nRF = 3V
VIH	0.7* VCC_nRF (Min.); VCC_nRF (Max.)
VIL	GND (Min.); 0.3* VCC_nRF (Max.)
GPIO VOH at 5mA load	VCC_nRF-0.3 (Min.); VCC_nRF (Max.)
GPIO VOL at 5mA load	GND (Min.); 0.3 V (Max.)
GPIO VOH at 0.5mA load	VCC_nRF-0.3 (Min.); VCC_nRF (Max.)
GPIO VOL at 0.5mA load	GND (Min.); 0.3V (Max.)
Pull-up resistance	13 KΩ
Pull-down resistance	13 KΩ
Typical Current Consumption TA=25oC, VCC_nRF = 3V
TX mode, 0 dBm output ower, no peripherals active, low MCU activity	10.5 mA (Typ.)
TX mode, 5dBm output power, no peripherals active, low MCU activity	16 mA (Typ.)
RX mode, standard mode, no peripherals active, low MCU activity	13 mA (Typ.)
Active, Run current at 16Mhz (XOSC) Executing code from flash memory	4.1mA
Current drawn by 1V2 regulator and 16Mhz XOSC when both are on at the same time	8100 uA (Typ.)
For HFCLK in 1Mhz mode3, Current drawing by 1V2 regulator and 16Mhz XOSC when both are on at the same time	520 uA (Typ.)
SYSTEM-ON base current with 16KB RAM enabled	3uA
Additional current in SYSTEM-OFF per retained RAM block (8KB)	0.6uA (Typ.)
RF Character TA=25oC, VCC_nRF = 3V
Frequency Range	2402 ~ 2480 MHz
Channel Spacing	2 MHz (Typ.)
Output Power	-30 ~ 4 dBm
Receiver Sensitivity	-89 dBm (Typ.)
Frequency error tolerance	-250 ~ 250 KHz

BT10-1

BT10-1

Bluetooth 4.2 and Proprietary 2.4Ghz Module

FEATURE

SPECIFICATION

Informations

Data Sheet

CONTACT DIGIMORE TECH SUPPORT

Community